1
3.5 Programming the Setup Functions
3.5.4 Tilt Over Angle ([MENU] Button
_
Setup
_
Tilt Over Angle)
This function is used to set the limit of the horizontal view angle (Tilt), so that the trim ring
or the ceiling does not obstruct the horizontal image when zooming-out (Wide Angle).
1. Press the [Menu] button on the Controller Keyboard. Select the ‘SETUP’ option. Scroll
down to ‘TILT OVER ANGLE,’ then press the Joystick handle to the right to access the
sub-menu.
•
‘ON’ - When it is desirable to see above the horizon, switch the function ‘ON,’ to view
additional 5º above the horizon. Although the ceiling line and the trim ring is now visable
during wide angle view, the viewing angle will narrow during zooming-in operation to
clear the obstructed view.
•
‘W/O BUBBLE’ - The tilt range of the PTZ dome camera is limited and the view is
partially obstructed.
•
‘WITH BUBBLE’ - The tilt range of the PTZ dome camera is limited to view only below
the horizon (-10º). The view is NOT obstructed.
2. Once the desired changes have been made, scroll down to the bottom to ‘SAVE AND
EXIT.’
Note:
You must ‘SAVE AND EXIT’ to finalize the programming, pressing [ESC] button
while programming will exit programming without saving.
VIEW ANGLE SETUP
TILT OVER ANGLE : ON
SAVE AND EXIT
