1
3.3 Programming the Screen Functions
3.3.4 Zone Title (Continued)
2. To enter the Zone Title, while highlighting ‘01,’ twist the Joystick handle. Once the desired
custom name has been entered, press down on the Joystick handle.
3. Move the cursor to ‘START,’ while pressing down the [Shift] button, aim the camera to the
start area. Once the camera is pointed to the desired location, release the [Shift] button to
designate the ‘START’ area.
Alternatively, you may initiate the view selection by twisting the Joystick handle. When
prompted, aim the camera to the desired location, then press the [Near] or the [Far] button
to designate the start area.
4. Repeat the same method described above, designate the ‘END’ area.
5. Repeat steps 2~4 for each available slot until all the desired Zone Titles has been
entered.
6. Finish the Zone Title programming by scrolling down to the bottom to ‘SAVE AND EXIT.’
Note:
You must ‘SAVE AND EXIT’ to finalize the programming, pressing [ESC] button while
programming will exit programming without saving.
ZONE TITLE
01/04
NO TITLE START END
01 WINDOW 123.4 345.6
02 ----- ----
03 ----- ----
04 ----- ----
05 ----- ----
06 ----- ----
PREV NEXT
SAVE AND EXIT
