1
3.1.4 Scan (Continued)
4. Move the cursor down to the ‘START’ option. While pressing down the [Shift] button, use
the Joystick and aim the camera to the desired start location. Release the [Shift] button to
designate the start position.
Alternatively, you may select the start position by twisting the Joystick handle. Aim the
camera to the desired start location, then press the [Near] or the [Far] button to designate
the start position.
5. Move the cursor down to the ‘END’ option. Using the same method described above,
designate the end position.
6. Move the cursor down to the ‘DIR.’ option. Determine the direction of the Scan to either
‘CW’ or ‘CCW.’
7. Move the cursor down to the ‘SWAP’ option. You can swap the ‘START’ position with the
‘END’ position using this option.
8. Finish the Scan programming by scrolling down to the bottom to ‘SAVE AND EXIT.’
Note:
You must ‘SAVE AND EXIT’ to finalize the programming, pressing [ESC] button while
programming will exit programming without saving. If the PTZ dome camera’s OSD menu
is being access through the DVR, access the PTZ menu and press the [ESC] button on the
DVR or [E] button on the EV Series DVR.
Deleting the Programmed Scan -
To delete a programmed Scan, press [Home] or [DEL]
button while highlighting the undesirable Scan.
3.1 Programming the PTZ Functions
