Novexx Solutions ALS 30 Series, Руководство по установке

Страница: 50 / 59

Installation Manual
ALS 30x
02/2016 | 00 50 Installation and Deinstallation
Pin assignment
Setting the roll diameter
Prerequisite:
– OD sensor is installed an activated.
– Label material roll with the required remaining diam-
eter is prepared.
 Measure the diameter of the prepared roll.
 Loosen the thumb screws [86A] at the reflector.
 Shift the reflector to position A [85A] or B [85B]
(long holes) according to the measured roll dia-
meter (--> tab.). Retighten the thumb screws.
 Insert the prepared label roll.
 Loosen the thumb screws [86B] at the sensor.
 Rotate the sensor, until the light beam does not
meet the reflector any more.
– The LED at the sensor is off.
 Slowly rotate the sensor backwards, until the light
beam meets the reflector.
– The LED at the sensor lights up.
 Rotate the sensor further, until the light beam is
covered by the label roll.
– The LED at the sensor goes out.
 Tighten the thumb screws.
Pin Assignment
1 +24 V
2 not used
3 Ground
4 Sensor signal
[Tab. 5] Pin assignment for OD sensor connection
Roll Ø in
mm Roll Ø
in Inch Reflector
position
38-122 1.5-4.8 A
51-135 2.0-5.3 B
1 2
3 4
[85] Setting the OD sensor
A Reflector position A (solid line)
B Reflector position B (dotted line)
C Sensor
D Rotating range of the sensor
[86] Rear view on the OD sensor.
A
B
C
A
B
D
C
A
B