Novexx Solutions ALS 30 Series, Руководство по установке

Страница: 42 / 59

Installation Manual
ALS 30x
02/2016 | 00 42 Installation and Deinstallation
Adjusting the Wenglor photoelectric sensor
automatically
Only for Wenglor sensors (old standard, replaced since
9/2011 by Novexx sensor).
 Call up MACHINE SETUP > Auto Sensor Adj.
– The label material is fed slowly until the next gap
between labels (punch) is reached. The photoelec-
tric label sensor is automatically adjusted in the
process.
Adjusting the Wenglor photoelectric sensor
manually
Only for Wenglor sensors (old standard, replaced since
9/2011 by Novexx sensor).
For dispensing label material with a low contrast, it can
be necessary to adjust the label sensor manually:
 Call up MACHINE SETUP > Sensor Adjust .
– Display:
 Place backing paper in the fork of the photoelectric
sensor.
 Press the key, until the LED [69A] on the photo-
electric sensor lights up.
 Press the key and keep it pressed just beyond
the point where the LED goes out.
 Note the displayed value (value 1).
 Place label material in the fork of the photoelectric
sensor.
– The LED will light back up.
 Press the key and keep it pressed just beyond
the point where the LED goes out.
 Note the displayed value (value 2).
 Calculate value 3:
– Value 3= ( value 1 + (value 2 - value 1) / 2)
 Set value 3 by means of the two arrow keys and ac-
knowledge the adjustment by pressing the
key.
Sensor Adjust
Manual: xx%
[69] LED (A) at the (Wenglor) photoelectric label sensor
A