Novexx Solutions ALS 30 Series, Руководство по установке

Страница: 45 / 59

Installation Manual
ALS 30x
02/2016 | 00 45 Installation and Deinstallation
Positioning the sensor holder:
The sensor holder be varied in a wide range on the hol-
ding rods. The most favorable position can be found as
follows:
– Label web is in stop position (position just after
dispensing a label).
 Push the sensor holder over a label gap and fix it
there.
– In this position should be possibly few labels bet-
ween dispensing edge and (capacitive) sensor.
– Fine adjustment of the stop position is done in the
same way as with the standard label sensor.
Leuze sensor setting:
 Remove label material from the sensor fork.
 Turn potentiometer [73B] to the right, until a light
click is audible (= max. sensitivity). Turn the poten-
tiometer
½
turn to the left.
 Turn potentiometer [73D] until both LEDs [73C]
shine equally bright (= base adjustment).
 Move the label web through the sensor fork and
watch the switching output LED.
– The LED [73C] must shine in label gaps.
 If case of insufficient switching behaviour, change
the sensitivity setting.
 After increasing the sensitivity setting, the base ad-
justment must be repeated.
– See www.leuze.de
Di-Soric sensor setting:
 Insert label material into the sensor fork.
– The label material must lie on the bottom fork arm
[74D].
 Press the button [74C], until the mode LED [74B,
yellow] lights up (approx. 2 s).
– The mode LED starts to flash quickly for approx.
2-4 s.
 During the mode LED flashes, move at least two la-
bels through the sensor fork.
Service and mode LEDs are flashing…
– 2x: The auto-teach procedure has been concluded
sucessfully. The service LED lights green.
– 4x: The label was not detected optimally, the best
possible switching point will be set. The service LED
lights red.
[73] Capacitive label sensor LEUZE GK14/24
A LED display switching output
B Set screw sensitivity
C LED display base adjustment
D Set screw base adjustment
[74] Capacitive label sensor di-soric KSSTI 1000/80 FG3LK-AIBS
A Service LED (grün/rot)
B Mode LED (gelb)
C Auto-teach button
D Bottom fork arm
B A C D
B A C
D