Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007, Руководство по установке

Страница: 583 / 982

1 Select a card from the list of detected cards in the YaST network card configura-
tion module and click Edit.
2 In the Address tab, click Advanced > Hardware Details.
3
In Options, enter the parameters for your network card. If two cards are configured
that use the same module, these parameters are used for both.
4
Click OK.
5 Click Next.
6
To activate configuration, click Finish.
Starting the Device
If you use the traditional method with ifup, you can configure your device to start during
boot, on cable connection, on card detection, manually, or never. To change device
start-up, proceed as follows:
1 Select a card from the list of detected cards in the YaST network card configura-
tion module and click Edit.
2 In the General tab, select the desired entry from Device Activation.
3
Click Next.
4 To activate the configuration, click Finish.
Configuring the Firewall
Without having to enter the detailed firewall setup as described in Section 43.4.1,
“Configuring the Firewall with YaST” (page 822), you can determine the basic firewall
setup for your device as part of the device setup. Proceed as follows:
1 Select a card from the list of detected cards in the YaST network card configura-
tion module and click Edit.
2 Enter the General tab of the network configuration dialog.
Basic Networking 565