Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007, Руководство по установке

Страница: 293 / 982

chkconfig --add o2cb
When you add a new service,
chkconfig
ensures that the service has either a
start or a kill entry in every run level.
3 If the
ocfs2
service is not already enabled, enter
chkconfig --add ocfs2
4
Configure the
o2cb
cluster service driver to load on boot.
4a Enter
/etc/init.d/o2cb configure
4b At the
Load O2CB driver on boot (y/n) [n]
prompt, enter
y
(yes) to enable load on boot.
4c
At the
Cluster to start on boot (Enter “none” to
clear) [ocfs2]
prompt, enter
none
This choice presumes that you are setting up OCFS2 for the first time or re-
setting the service. You specify a cluster name in the next step when you set
up the
/etc/ocfs2/cluster.conf
file.
5 Use the
ocfs2console
utility to set up and save the
/etc/ocfs2/cluster
.conf
file to all member nodes of the cluster.
This file should be the same on all the nodes in the cluster. Use the following
steps to set up the first node. Later, you can use the
ocfs2console
to add new
nodes to the cluster dynamically and to propagate the modified
cluster.conf
file to all nodes.
Oracle Cluster File System 2 275