Norwood Kwik-Pit 26 Series, Руководство оператора

Страница: 107 / 133

5 - MAINTENANCE
5-29
As Required
Replace the Hopper Flaps
If material is leaking through the hopper flaps, it may be time
to change the rubber flaps.
1. If the machine is in the raised position, Install transport
locks on left and right side of the lift axles to avoid cyl -
inders settling during servicing.
(See"Transport Locks:
Locking & Stowing" on page 4-12)
WARNING
• Hydraulic Drive Option: Engage park brake, place
transmission in PARK, shut off engine, remove key,
and wait for all moving parts to stop before leaving
the tractor cab.
• Electric Drive Option: Turn machine OFF, shut down
and lock out power source, unplug power cord and
wait for all moving parts to stop before inspecting,
servicing or repairing machine.
• Keep body, hair, and clothing away from moving con -
veyor belt and rollers.
• Do not operate with any guards removed or modified.
Keep guards in good working order. Failure to comply
could result in death or serious injury.
1. Raise the Hopper Flaps (See"Hopper Flaps Raise / Lower
Control Lever" on page 4-8)
Fig. # 5-41 Raise the Hopper Flaps
F
2. Loosen and remove the " 1/4-20 Nuts" D & " 1/4-20
Elevator Bolts"
C
. (See Fig. # 5-42)
3. Remove and replace the " Worn Hopper Flaps" A &
B
. (See Fig. # 5-42)
Fig. # 5-42 Replace Hopper Flaps
B
C
A
D
4. Re-install the " 1/4-20 Elevator Bolts"
C
& " 1/4-20 Nuts"
D
.
5. Run the machine and check for leaks. If the flashing is
stuck to the belt, manually peel the flashing off the belt.
Replace it if necessary.