Norwood Kwik-Pit 26 Series, Руководство оператора

Страница: 112 / 133

5 - MAINTENANCE
5-34
11. Notch the conveyor belt as necessary in order to keep
belt from catching the conveyor framework. Notch only
the trailing end of the conveyor belt.
(See Fig. # 5-56)
Belt Direction
0.50"
0.25"
Fig. # 5-56 Notch The Belt
6. Reattach the conveyor belt ends together. If required,
use a ratchet strap clamped to both ends of the belt to
cinch the belting ends together. (See Fig. # 5-53)
7. Install the lacing pin and bend the ends of the lacing pin
away from belt travel direction.
A
Fig. # 5-57 Install The Lacing Pin
8. Crimp the "Retainer clips"
C
onto each end of the
"Lacing Pin"
L
using an "Adjustable Pliers"
P
.
Fig. # 5-58 Crimp The Retainer Clips Onto Each End Of
The Lacing Pin.
P
L
C
9. Remove the ratchet strap and set the correct tension for
the conveyor belt.
(See"Conveyor Belt Tension" on page
5-8)
10. Check and set the belt alignment.
(See"Conveyor Belt
Alignment" on page 5-10)
11. Engage the conveyor belt. Allow the conveyor to run for
30 seconds, then shut down the conveyor and inspect
the lacing.