Norwood Kwik-Pit 26 Series, Руководство оператора

Страница: 108 / 133

5 - MAINTENANCE
5-30
As Required
Replacing the Conveyor Belt
The belt provided on your Kwik-Pit should last for several
years under normal working conditions, providing it is
maintained properly. If a new belt is to be installed, be sure
to loop the belt through properly. Looping the Conveyor belt
improperly will cause belt tracking, belt tensioning, and belt
lacing problems. The recommended procedure to replace a
belt is:
1. If the machine is in the raised position, Install transport
locks on left and right side of the lift axles to avoid cyl -
inders settling during servicing.
(See"Transport Locks:
Locking & Stowing" on page 4-12)
WARNING
• Hydraulic Drive Option: Engage park brake, place
transmission in PARK, shut off engine, remove key,
and wait for all moving parts to stop before leaving
the tractor cab.
• Electric Drive Option: Turn machine OFF, shut down
and lock out power source, unplug power cord and
wait for all moving parts to stop before inspecting,
servicing or repairing machine.
• Keep body, hair, and clothing away from moving con -
veyor belt and rollers.
• Do not operate with any guards removed or modified.
Keep guards in good working order. Failure to comply
could result in death or serious injury.
2. Rotate the conveyor belt until the "Lacing" C is by the
"Return Roller" D . (See Fig. # 5-43)
Fig. # 5-43 Rotate Conveyor Belt So Lacing Is Next To The
Return Roller
C
D
3. Remove the Return Roller.
(See Fig. # 5-44)
E
E
D
PRESS
PRESS
Fig. # 5-44 Remove the Return Roller
4. Loosen “Bearing Nuts”
A
and “Jam Nuts”
B
at the
hopper pulley. (See Fig. # 5-45)
A
A
B
Fig. # 5-45 Loosen Bearing and Jam Nuts