Norwood Kwik-Pit 26 Series, Руководство оператора

Страница: 105 / 133

5 - MAINTENANCE
5-27
200 Hours Or Annually
Inspect The Inlet Flashing
The inlet flashing is located near the hitch end of the Kwik-
Pit right behind the inlet cover. It is made of rubber and can
wear over time. It should be inspected at least once a year.
1. If the machine is in the raised position, Install transport
locks on left and right side of the lift axles to avoid cyl -
inders settling during servicing.
(See"Transport Locks:
Locking & Stowing" on page 4-12)
WARNING
• Hydraulic Drive Option: Engage park brake, place
transmission in PARK, shut off engine, remove key,
and wait for all moving parts to stop before leaving
the tractor cab.
• Electric Drive Option: Turn machine OFF, shut down
and lock out power source, unplug power cord and
wait for all moving parts to stop before inspecting,
servicing or repairing machine.
• Keep body, hair, and clothing away from moving con -
veyor belt and rollers.
• Do not operate with any guards removed or modified.
Keep guards in good working order. Failure to comply
could result in death or serious injury.
2. Inspect the "Inlet Flashing"
A
for wear.
(See Fig. #
5-39)
A
Fig. # 5-39 Inspect the Inlet Flashing
3. If necessary, replace the "Inlet Flashing"
A
by removing
the (Qty. 6) "1/4-14 X 1 Screws" B .
(See Fig. # 5-40)
B
B
B
A
B
B
B
Fig. # 5-40 Replacing the Inlet Flashing