Nortel 1002rp, Техническое обслуживание и диагностика

Страница: 76 / 218

Using CallPilot Manager to monitor hardware Standard 1.11
76 CallPilot
Viewing component states
View a component state to determine the general condition of the
component, including whether the component is disabled or off duty.
The component state is shown in the Maintenance section of the
Maintenance screen.
Component states
You can determine the state of a component by looking at the State box
in the Maintenance section.
State Description
Active The component is working and currently involved in
processing a call.
Disabled The diagnostic failed.
Idle The component is working but not currently
involved in processing a call.
InTest A diagnostic is running on the resource or device.
Loading The component has been started, which takes it out
of the Off Duty state.
This state occurs quickly and is immediately
followed by Idle.
Local (Red) Alarm A Receive Loss of Synchronization error occurred
on incoming data over a T1 link and lasted more than
2.5 seconds. This condition will exist until
synchronization is recovered and remains recovered
for 12 seconds.
No resources The hardware required for the component to operate
is not installed or is not operating properly.