Nortel 1002rp, Техническое обслуживание и диагностика

Страница: 179 / 218

January 2007 Upgrading to High Capacity
1002rp Server Maintenance and Diagnostics 179
4 Remove the server cover.
For instructions on removing the server cover, see “Removing the
front bezel and server cover” on page 110.
5 Disconnect the CT Bus cable (if present).
6 Ensure that the current configuration is as follows (this is standard
for a 96-channel configuration):
a. There is an existing MPB96 board in PCI slot 3.
b. There is an existing Intel D/480JCT-2T1 PCI card in slot 4, and
its SW100 ID rotary dial switch is set to 0.
c. There is an existing Intel D/480JCT-2T1 PCI card in slot 5, and
its SW100 ID rotary dial switch is set to 1.
7 Remove any termination jumpers from the Intel D/480JCT-2T1 PCI
cards. For jumper location, see Figure 35 on page 177.
8 Plug the first additional MPB96 card into PCI slot 6.
9 On the first additional Intel D/480JCT-2T1 PCI card:
a. Set the card’s SW100 ID rotary dial switch to 2.
b. Ensure that there are no termination jumpers installed on P700.
c. Plug the card into PCI slot 7.
10 On the second additional Intel D/480JCT-2T1 PCI card:
a. Set the card’s SW100 ID rotary dial switch to 3.
b. Ensure that there are no termination jumpers on P700 pins 3
and 4.
c. Plug the card into PCI slot 8.
11 Plug the second additional MPB96 card into PCI slot 9.
12 Connect the 7 drop CT Bus cable to ensure that the connectors are
connected to the end cards and no connector is left dangling at any
end of the cable.
13 Replace the server cover.
14 Replace the front bezel and lock it.
15 Reconnect the peripheral device and power cables.