Nortel 1002rp, Техническое обслуживание и диагностика

Страница: 154 / 218

Replacing media drives Standard 1.11
154 CallPilot
Note: Some settings may already be properly configured. If it is not clear
from the drive manufacturer’s documentation how to set jumpers,
contact your Nortel technical support representative.
1 Set the SCSI ID to 6.
2 Disable the Active Terminators (Term Enable).
Note: Termination is provided by an active SCSI terminator that you
connect to the end of the SCSI cable (see “Cabling example” on
page 153).
3 Enable Parity Checking.
4 Enable Termination power (TPWR).
5 Leave the remaining settings at the default values.
To install a new tape drive (no tape drive
previously installed)
1 Courtesy down CallPilot, and then power down the server.
2 Ensure that the tape drive settings are as described in “”To
configure the tape drive””.
3 Remove the chassis cover.
4 Remove the media drive carrier (see “Removing the media drive
carrier from the chassis” on page 145).
5 Slide the new tape drive into the media drive carrier, and secure it
with four undercut Phillips-head screws.
Note: You may need to first remove other media drives from the
carrier to access the tape drive slot.
.
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.