Operation
A 5-5
Part 331235C
E
2003 Nordson Corporation
Part A: System Overview
Daily Operation
NOTE:
If the system has an application controller, all set points are
adjusted through the application controller. Refer to Part G:
Application
Controller
in this manual for more information.
1. Complete the
Startup
procedure.
2. Put the system keyswitch in the BYPASS position while you are making
initial adjustments to the guns.
NOTE:
Figure A 5-3 shows the typical display when the gun is triggered.
Refer to the
Description
section in this part of the manual for more
information about the display.
1400869A
Figure A 5-3
Typical Display in STD Mode with Gun Triggered
3. If your system is connected to either Versa-Spray or Sure Coat
automatic guns, select the appropriate operating mode for your
application. Refer to
IPS Gun Operating Modes
in this section to select
the appropriate operating mode for your application.
4. Use Table A 5-4 to verify the correct data on the display.
Содержание Sure Coat
