NorAM 65E Turbo, Руководство по обслуживанию

Страница: 28 / 613

65E Turbo Motor Grader
Service Manual
Service 1.00_2006.03
Section 1
Engine
1-11
* Indicates multiple errors can generate this fault code.
517
Yellow
S251 12 1076 12 A mechanically stuck fuel control valve
has been detected by the VP44 fuel
pump controller.
Engine may shut down.
524
Yellow
P113 2 113 2 Error detected on the High Speed
Governor Droop selection switch input pin
24 of the engine harness.
Operator can not select alternate HSG
Droop. Normal droop is used.
527*
Yellow
P154 3 702 3 Error detected in the Dual Output Driver
"A" circuit pin 5 of the OEM harness.
The device controlled by the Dual Output
Driver "A" signal will not function
properly.
528
Yellow
P093 2 093 2 Error detected on the Torque Curve
Selection switch input pin 39 of the OEM
harness.
Operator can not select alternate torque
curves. Normal torque curve is used.
529*
Yellow
S051 3 703 3 Error detected in the Dual Output Driver
"B" circuit pin 21 of the engine harness.
The device controlled by the Dual Output
Driver "B" signal will not function
properly.
551 Yellow P091 4 091 4 Idle validation signals on pins 25 and 26
of the OEM harness indicate no voltage
on either pin.
Engine will only idle.
599 Red S02514 64014 The dual output feature in the customer
specialized calibration, has initiated an
engine shutdown based on operating
conditions, engine sensor values, or
OEM inputs to the ECM.
Engine will shut down.
611* S151 0 1020 0 ECM detected the engine has initiated a
protection shutdown or has been keyed-
off while above a specified load limit.
No effect.
768
Yellow
S009 11 92311 Error detected in the Output Device
Driver (Transmission Shift Modulation
Signal) signal pin 21 on the OEM
harness.
Can not control the Transmission.
Fault
Code
Lamp
PID(P)
SID(S)
FMI
SPN(S)
FMI
Reason Effect (Only when fault code is
active)