Nibe CLIMACOOL UCR 30, Инструкция по установке, эксплуатации и обслуживанию

Страница: 22 / 84

20
www.climacoolcorp.com
Water Piping Configurations
Notes:
1 . Figures 13 and 14 are required piping for proper water regulation and distribution through ClimaCool modular chillers .
2. Module order and incoming/outgoing water flow as shown in both Figure 13 and 14 can be set up as either a left-to-right
or right-to-left configuration.
3. Piping configurations are similar for the chilled water hydronic circuit.
4 . For chilled water inlet/outlet location dimensions, refer to page 8 - Dimensional Data and Drawings .
5. A pressure differential flow sensor is a required safety device for ClimaCool modular chillers on the chilled water circuits .
6 . A strainer with a minimum of 60 mesh stainless steel screen is a required safety to protect the brazed plate heat exchangers on
chilled water side of the system .
7. Maximum water flow rates for chilled water header system for 30, 50 and 70 ton modules in one bank is 1,000 gpm.
8 . Bypass is mandatory for systems utilizing motorized valves .
9 . Header bypass valve may be installed at either end of bank .
10 . For over seven (7) modules, consult the factory and note 2 CoolLogic controller are required .
Figure 13 - Field Piping Direct Return
Figure 14 - Field Piping Reverse Return