NF ZM2371, Инструкция по эксплуатации

Страница: 69 / 255

3.5 Basic Operations
3-39 ZM2371/ZM2372

Selection of trigger source
_ SHIFT _ + [ TRIG MODE ]
Press the
_ SHIFT _ + [TRIG MODE]
keys to display the trigger setting menu.
Trigger source Trigger delay Triggered drive
T R I G S R C : E x t D e l a y = 1 0 0 . 0 0 0 s S R C S y n c = O N
Current setting
0 ) I n t 1 ) M a n 2 ) E x t 3 ) B u s 4 ) D e l a y 5 ) S . S y n c
Options
Int Internal trigger. Upon completion of measurement, a
trigger is applied automatically and measurement is
executed continuously. Other trigger signals are ignored.
Man Manual trigger. Press the
_ TRIG _
key on the front panel to
apply a trigger signal.
Ext External trigger
A trigger is applied with *TRIG signal through the handler
interface.
Bus A trigger is applied by the remote control.
*Refer to the description of *TRG and GET.
Delay Displays the trigger delay setting menu.
S.Sync Displays the triggered drive setting menu.
Select a trigger source or perform the EXIT operation to return to the measurement
screen.
BUSY SOURCE SYNC _ SHIFT _ _ TRIG _ | [TRIG MODE]
Current trigger source is displayed on the second line of measurement screen (in case of
status display).
A 1 0 0

F A S T 2 5 6 I n t O p S h L d 1 m
・ ・ ・ ・ ・ ・
TRIG SOURCE
Trigger source: Int / Man / Ext / Bus

Applying a trigger (measurement start)
_ TRIG _
When the trigger source is Man (manual) and the measurement has not been executed, if
the
_ TRIG _
key is pressed, the measurement starts and it is executed only once. One-time
measurement will take time when the frequency is lower than 1Hz, or the number of
averaging count is large. Note that the last measured value is displayed during the
measurement.
BUSY lamp
During measurement, the BUSY lamp lights up or blinks.
Trigger source