NF ZM2371, Инструкция по эксплуатации

Страница: 132 / 255

5.1 Preparations Before Use
5-5 ZM2371/ZM2372
5.1.3 Outline of RS-232
5.1.3.1 Preparation of Controller
When using the RS-232 interface, prepare a controller equipped with the connector for serial
communication (RS-232) or install the interface card for serial communication in the
controller.
Adjust the following parameters between
ZM2371 / ZM2372
and controller:
・
Data rate 4800 to 230400 bps
・
Data length 8 bits
・
Stop bit length 1 at transmission, 1 at reception
・
Parity None
・
Handshake None / Software / Hardware
・
Terminator CR / LF / CR LF
5.1.3.2 Preparation of ZM2371 / ZM2372
If RS-232 is selected with the remote control interface setting menu, the RS-232 setting
menu is displayed as shown below. Go to the sub menu for setting.
R S - 2 3 2
0 ) D a ta R a t e 1 ) Te r m i n a t o r > N E X T
Options (first page)
2 ) H a n d s h a k e < P R E V
Options (second page)
Data Rate
Displays the data rate setting menu.
Terminator
Displays the message terminator setting menu when data is
transmitted from
ZM2371 / ZM2372
.
Handshake
Displays the handshake setting menu.
Perform the EXIT operation to return to one-previous menu.
The following parameters are fixed on the
ZM2371 / ZM2372
. Adjust the settings on the
controller side.
•
Data length 8 bits
•
Stop bit length
1 at transmission, 1 at reception
•
Parity
None