NF ZM2371, Инструкция по эксплуатации

Страница: 133 / 255

5.1 Preparations Before Use
5-6 ZM2371/ZM2372

Data rate
The RS-232 data rate setting menu is as shown follows.
R S - 2 3 2 D a ta r a t e : 9 6 0 0 b ps
Current setting
0 ) 4 8 0 0 1 ) 9 6 0 0 2 ) 1 9 2 0 0 3 ) 3 8 4 0 0 > N E X T
Options (first page)
4 ) 5 7 6 0 0 5 ) 11 5 2 0 0 6 ) 2 3 0 4 0 0 < P R E V
Options (second page)
Perform the EXIT operation to return to one-previous menu.
If the data rate is set, the result is displayed for a moment, and one-previous menu comes
back.
The data rate is common to the transmission and reception.
Select the rate at which the communication can be made stably within the data rate range
provided by both
ZM2371 / ZM2372
and controller. Even if a selection is made, when the data
rate exceeds 19200 bps, stable communication may not be performed due to the restrictions
of cable. For high speed communication, a short cable having low capacitance should be
used.

Message terminator
A terminator indicating the termination is required at the end of a set of commands or
response.
The RS-232 message terminator setting menu is as shown below.
R S - 2 3 2 Te r m i n a t o r : L F
Current setting
0 ) C R 1 ) L F 2 ) C R L F
Options
CR
Uses one character CR (Carriage Return) as a terminator.
LF
Uses one character LF (Line Feed) as a terminator.
CR LF
Uses two characters CR and LF as a terminator.
Perform the EXIT operation to return to one-previous menu.
•
When
ZM2371 / ZM2372
transmits data
The set terminator is added at the end of response message.
•
When
ZM2371 / ZM2372
receives data
The command is executed when CR or LF, whichever comes first, is received.
If the message terminator is set, the result is displayed for a moment, and one-previous
menu comes back.