NF HSA42011, Инструкция по эксплуатации

Страница: 39 / 86

3.4 I/O Connection
HSA42011 3-9
3.4 I/O Connection
Figure 3-6 Basic Connection Diagram
shows the connection diagram.
For full performance of this product, connect a signal generator, signal cords, and a load, observing the
descriptions provided in "
3.4.1 Signal generator
" through "
3.4.3 Load
".
本製品
WF シリーズ
1CH 30 MHz
信号発生器
オシ ロスコープ
10：1プローブ
負荷
Figure 3-6. Basic Connection Diagram
3.4.1 Signal generator
When using a high frequency of 100 kHz or higher, use a signal generator with an output impedance of 50

and set the input impedance of this product to 50

When the output impedance of a signal generator is not 0

but 50

, for example, the output voltage of
the signal generator needs to be set considering the input impedance of this product.
To obtain a necessary input voltage, set the voltage of the signal generator as follows:




1 +
信号発生器の出力インピーダンス
BA4825 の入力インピーダンス設定
Times
* With WF series, an output voltage for an arbitrary load impedance (1

to 10k

) can be set.
Output impedance of signal generator
Input impedance setting of this product
WF series
1CH 30MHz
Signal generato
r
This product
Oscilloscope
10:1 probe
Load