NF HSA42011, Инструкция по эксплуатации

Страница: 70 / 86

6.4 Performance Testing
HSA42011 6-14
The performance of this product is normal if the following criteria are satisfied:
Table 6-1. Judgment of HSA42011 Performance
6.4.1
Measurement of
maximum output voltage
(at 20 Hz, 40 Hz,
500 kHz, and 1 MHz)
Set frequency Criterion
Measured
value
Judgment
20 Hz 45 Vrms or more _ _ . _ _ Pass/Fail
40 Hz 53 Vrms or more _ _ . _ _ Pass/Fail
500 kHz 53 Vrms or more _ _ . _ _ Pass/Fail
1 MHz 53 Vrms or more _ _ . _ _ Pass/Fail
6.4.2
Measurement of
maximum output power
[Voltage immediately
before the overload LED
(OVLD) is turned on]
Frequency
Terminating
resistor
Criterion
Measured
value
Judgment
DC 75

75 V or more _ _ _ . _ Pass/Fail
6.4.3
Measurement of
frequency characteristics
(at 100 kHz, 500 kHz,
and 1 MHz with the value
at 400 kHz used as a
reference (0 dB))
Set frequency Criterion
Measured
value
Judgment
400 kHz 0 dB (reference) 0 . 00
Used as
reference
100 kHz

1.0 to +1.0 dB _ _ . _ _ Pass/Fail
500 kHz

3.0 to +1.0 dB _ _ . _ _ Pass/Fail
1MHz

3.0 to +1.0 dB _ _ . _ _ Pass/Fail
6.4.4
Measurement of gain
accuracy
At Gain

1 (CAL)
，
 10 (CAL)
，

20 (CAL)
，

50 (CAL)
Gain setting FRA output voltage Criterion
Measured
value
Judgment

1 (CAL) 10 Vpeak 0.95 to 1.05 _ _ . _ _ Pass/Fail

10 (CAL) 10 Vpeak 9.5 to 10.5 _ _ . _ _ Pass/Fail

20 (CAL) 7.5 Vpeak 19.0 to 21.0 _ _ . _ _ Pass/Fail

50 (CAL) 3.0 Vpeak 47.5 to 52.5 _ _ . _ _ Pass/Fail
6.4.5
Measurement of sine
wave distortion ratio
(at each frequency)
Set frequency Criterion
Measured
value
Judgment
40 Hz 0.1% or less 0 . _ _ _ Pass/Fail
1 kHz 0.1% or less 0 . _ _ _ Pass/Fail
100 kHz 0.5% or less 0 . _ _ _ Pass/Fail
6.4.6
Measurement of
bias-added voltage
(at each dial scale mark)
Dial setting Criterion
Measured
value
Judgment
0.71 About

75 V

_ _ _ . _ _ Pass/Fail
9.29 About +75 V +_ _ _ . _ _ Pass/Fail