NF HSA42011, Инструкция по эксплуатации

Страница: 21 / 86

2.2 Installation
HSA42011 2-3
2.2 Installation

Installation location
Do not place this product, with its rear or side facing down, on a floor or desk.
Ensure that all of the four rubber legs at the bottom are placed on a plane surface such as a desk.

Caution on transportation
When transporting this product, hold on the sides and ensure that the product is level.

Installation location conditions

Use this product indoors at an altitude of no higher than 2000 m.

This product performs forced air cooling using fans. Separate the front, rear, and sides with
air inlets and air outlets from the wall by 50 cm or more to assure ventilation.

Install this product in a location that satisfies the following temperature and humidity ranges:
Operation
guarantee
0

C to +40

C
5 % to 85 % RH.
Absolute humidity 1 to 25 g/m
3
, with no
condensation.
Performance
guarantee
+5

C to +35

C
5 % to 85 % RH.
Absolute humidity 1 to 25 g/m
3
, with no
condensation.
Storage
condition

10

C to +50

C
5 % to 95 % RH.
Absolute humidity 1 to 29 g/m
3
, with no
condensation.
Product reliability may decline in extreme temperature and/or humidity environments. An
environment of approximately 25

C and 50%RH is recommended.

Do not install this product in the following locations:

Location with flammable gas

An explosion may occur. Never install and use this product in such a location.

Outdoors or location exposed to direct sunlight or near a fire or heat source

The full performance of this product may not be obtained, or failure may occur.

Location with corrosive gas, moisture, or high humidity

This product may become corroded or fail.

Location near an electromagnetic field source, high-voltage device, or power line

This product may malfunction.

Location exposed to excessive vibration

This product may malfunction or fail.

Location with excessive dust

In particular, electrically conductive dust may cause failure of this product.