NF HSA42011, Инструкция по эксплуатации

Страница: 35 / 86

3.3 I/O Terminals
HSA42011 3-5
3.3.2 Output connector (Main output)
A main output connector is provided.
For output voltage signal setting, refer to "
3.5.2 Output voltage adjustment
"to"
3.5.5 Output
polarity switching
".

Output connector BNC connector
Number of terminal: 2 (front panel and rear panel)
The Lo side is connected to the chassis.
The front panel and rear panel terminals are connected in parallel.

Maximum output voltage Resistance load 50

 
53 Vrms 40 Hz to 1 MHz
45 Vrms 20 Hz to 40 Hz
Resistance load 75


75 V DC to 1 MHz

Maximum output current (AC) 1.06 Arms
，
3 Ap-p (40 Hz to 1 MHz
）


Maximum output current (DC) ±1 A


Output impedance [ 0.19 + 0.0155 f

(1 + j ) ]

or less (typ.)
f represents frequency, its unit is Hz
The maximum output voltage of this product is

75 V. An electric shock can occur if the output
connector is directly touched. For safe use, be sure to observe the following:

Turn off the power when making connections.

Do not touch the output connector, output cable ends, load, or connected device terminals when
the power is on. In particular, never touch these parts with wet hands.
This product has two output connectors. For safety, attach the BNC cover to those that are not
connected to a load.
！
WARNING