NF HSA42011, Инструкция по эксплуатации

Страница: 72 / 86

7.1 Input
HSA42011 7-2
Unless otherwise noted, the following conditions are adopted after a warm-up period of 30 minutes at
least:
Item Description
Output waveform Sine wave
Output polarity In-phase
Load
Resistance 50

(power factor 1, nominal value)
Input impedance
50

Gain setting 
50 (CAL)
7.1 Input
Item Description
Input mode Input A, input B, or addition of input A and input B (when the
two inputs are on, provided that the maximum total voltage of
the two inputs is within

10 V)
Input impedance
Switchable between 50

5 % and 10 k

5 % (unbalance,
common setting for input of A and B)
Maximum input voltage 
10 V
Non-destructive maximum
input voltage 
11 V
Input terminal BNC connector
Number of terminals: 2
Input A: Front panel, Input B: Rear panel
The Lo side is connected to the chassis.