NF HSA42011, Инструкция по эксплуатации

Страница: 74 / 86

7.3 Monitor Output
HSA42011 7-4
7.3 Monitor Output
Item Description
Monitor ratio 1/100 of output voltage (1 V/100 V), in phase as output voltage
Monitor accuracy 
5.0 % (DC to 1 MHz)
(Error between the output voltage and conversion voltage
obtained from the monitor voltage, monitor output load
impedance 1 M

)
Output impedance
50

5 %
Output terminal BNC connector (rear panel)
7.4 Output LED meter
Item Description
Indicated data Output voltage and output current
11 LEDs display levels from 0 % to 100%
Detection method Average value detection (AC+DC), calibrated with a sine wave
Full scale (100 %) Voltage: 75 V
Current: 1.06 A
7.5 Protection Function
Item Description
Output overload When an excessive output current or an excessive internal power
loss is detected, the output current is clipped and the overload
LED on the front panel is lit. Output turns off if the overload
state lasts for 10 seconds or more. If the overload state lasts for
60 seconds, a transition is made to disable mode.
Output overvoltage Output turns off when an abnormality is detected. If the output
overvoltage state lasts for 60 seconds, a transition is made to
disable mode.
Power supply section
abnormality When an abnormality is detected, the error LED blinks, output
turns off, and a transition is made to disable mode.
Abnormal internal
temperature When an abnormality is detected, the overload LED on the front
panel is turned on. If the abnormal temperature state lasts for 10
seconds, output turns off. If the state lasts for 60 seconds, a
transition is made to disable mode.
FAN abnormality When an abnormality is detected, output turns off and a
transition is made to disable mode.
* Disable mode: All the operations except power-off are disabled.