NF HSA42011, Инструкция по эксплуатации

Страница: 24 / 86

2.4 Simplified Operation Check
HSA42011 2-6
2.4 Simplified Operation Check
This section describes the simplified operation check method, which may be used when this product is
newly purchased or after being stored for a long time. For performance checking, refer to
"6.4
Performance Testing
".
This product contains high-voltage parts. Never remove the cover.
All internal inspections of this product are to be performed only by service technicians qualified by
NF Corporation.
 Required measuring instruments
To make an operation check, the measuring instruments listed below are required.
No load test is conducted since a load (terminating) resistor is not needed.
Table 2-1. Required Measuring Instruments
Measuring instrument Characteristics
Signal generator
Frequency: 1 kHz
Waveform: Sine wave
Output voltage: 0.5 Vrms or more (Load: 50

WF1947 1 CH 30 MHz multifunction generator
manufactured by NF Corporation, or equivalent
Oscilloscope
Frequency bandwidth: 20 MHz or more
Use an oscilloscope that can measure 100 V or higher by
using a 10:1 probe
Note
.
Voltmeter
AC and DC voltage measurement
Use a voltmeter that can measure 100 V or higher.
Note: When connecting an oscilloscope for measurements, be sure to use a 10:1 probe.
！
WARNING