NF HSA42011, Инструкция по эксплуатации

Страница: 23 / 86

2.3 Grounding and Power Supply Connection
HSA42011 2-5
2.3 Grounding and Power Supply Connection

Be sure to ground this product.
This product uses a line filter. Be sure to ground this product. Otherwise, an electric shock may
occur.
To prevent an electric shock from occurring, be sure to ground this product so that the ground
resistance is 100

or less.
This product is automatically grounded when its 3-prong power supply plug is connected to a 3-pole
power outlet with a protective-ground contact.
This product does not come with a 3-prong to 2-prong conversion adapter. When using a separately sold
3-prong to 2-prong conversion adapter, be sure to connect the grounding wire of the adapter to the
grounding terminal next to the outlet.
The power code set can be used for disconnecting the product from AC power line in case of
emergency. Maintain enough space around the inlet, to be able to remove the connector of a power
cord from the inlet. Use a power socket located at convenient place with adequate space around so
that the plug can be removed from socket.

The power requirements of this product are as follows:
Voltage range: 100 V AC to 230 V AC

10
％
(not exceeding 250 V)
Overvoltage Category II
Frequency range: 50 Hz/60 Hz

2 Hz (single phase)
Power consumption: 290 VA or less

Connect the power supply according to the following procedure:
1. Check that the commercial voltage supply to be connected is within the voltage range of this
product.
2. Turn off the power switch of this product.
3. Insert the power cord supplied with the product into the inlet on the rear.
4. Insert the plug of the power cord into a 3-pole power outlet.
The power cord set delivered with this product is dedicated to this product.
Do not use the power cord for other products and applications.
Use only the attached power code set for connection to AC power line.
Note that the dielectric strength of only the main unit of this product is 1500 VAC.
！
WARNING
！ CAUTION
！
CAUTION