D-36
(8)
Automatic Document Feeder Sub-Scanning Zoom Ratio Adjustment
<Reference>
<Adjustment Procedure>
1. Print the test pattern.
2. Enter the “ADJUST” menu in the Service mode.
3. Load the test pattern into the Automatic Document Feeder and make a test copy.
NOTE
•
The test pattern should be positioned vertically.
•
Use A4 L or Letter L paper loaded into Tray 1 to make the test copy.
4. If the length of C in the copy of the test pattern is not the same as the length of C in the
test pattern, adjust it according to the following procedure.
5. Change the setting.
If the width of C in the test pattern is longer than the specified width . . . . .
Decrease the setting.
If the width of C in the test pattern is shorter than the specified width . . . . .
Increase the setting.
✽
If the shift cannot be adjusted to within the specification with a single adjustment, perform
the adjustment again to change the setting.
6. Press the Yes key to apply the setting.
NOTE
If the Stop key is pressed, instead of the Yes key, the main screen is displayed and the set-
ting returns to that before it was changed.
Load the test pattern into the Automatic Document Feeder again, make another test copy,
and check it.
Zoom Ratio
Specification
Mode
Function
Setting Range
Full Size
(100%)
200 ± 0.5 mm “ADJUST” menu ADF SUB ZOOM
95 to 105
1 increment = 0.4%
• Adjust the length of C in the copy of the test pat-
tern so that the following specification is met.
1382D009AA
C
Содержание NEFAX 671
Страница 1: ...SERVICE MANUAL FIELD SERVICE NEC Unified Solutions Inc NEFAX 671 691...
Страница 271: ...T 9 2 5 Location of Misfeed Detection Sensors Exit Sensor PS1 Paper Take Up Switch S1...
Страница 314: ...PF 125 Service Manual...
Страница 323: ......