T-41
(2)
Transmission
005B
Did not detect phase E signal after primary channel within 6 seconds.
005C Detect busy tone within control channel after phase C.
005D Remote-side disconnect at phase C (V.34).
005E
Did not detect control channel signal after received RCP frame within 6 seconds.
005F
Did not detect silence after sending JM signal for polling TX function.
0060
There are no bulletin files to be polled in V.34.
0061
Machine can not detect V.21 or V.8 signal within 35 seconds.
0062
Modem disconnect in phase D after our side sending out flag sequence in control
channel.
0063
Did not receive any flag sequence in control channel within 6 seconds in phase
D.
0064
Did not detect any control channel signal in phase D within 60 seconds even
though energy still on the line.
0065
Did not detect any control channel signal within 60 seconds after detect silence in
phase D.
0066
Did not receive T.30 signal or carrier signal after sending CFR in V.34.
0070
User presses stop key during receiving.
0071
Memory full during receiving.
Code
Possible Causes of Error.
0080
Did not detect any G3 signal within 35 sec. specified by ITU-T in phase B.
0081
Received DTC signal in transmission phase.
0082
Transmitting unit receives a signal other than DIS or DTC. and DCN in phase B.
0083
Detected FSK signal, but did not receive any signal within 35 seconds.
0084
Detect DCN signal in phase B.
0085
Transmitting unit sending DCS 3 times consecutively, but each time receiver
responds with DIS/DTC.
0086
Detected response signal other than DTC, DIS, FTT, DCN or CFR after sending
DCS.
0087
Training attempt has failed because speed unit cannot adjust to low lower speed.
0088
Received DCN signal after sending out DCS signal.
0089
Remote side no mailbox function or not compatible.
008A
Remote side not enough memory for relay initiate.
008B
Receiver's protocol of DIS is received, but it is not compatible with our machine.
008C Remote side not enough memory for relay initiate.
008D
Receiver's protocol of DIS is received, but remote side can't receive document
temporary, may be run out of paper or other reason.
008E
Remote side CSI number not defined in machine one touch or speed dial direc-
tory.
Code
Possible Causes of Error.
Содержание NEFAX 671
Страница 1: ...SERVICE MANUAL FIELD SERVICE NEC Unified Solutions Inc NEFAX 671 691...
Страница 271: ...T 9 2 5 Location of Misfeed Detection Sensors Exit Sensor PS1 Paper Take Up Switch S1...
Страница 314: ...PF 125 Service Manual...
Страница 323: ......