NEC N8100-14522F, Руководство пользователя

Страница: 235 / 320

Upgrading Your Server 9-7
DEVICE INSTALLATION OR REMOVAL PROCEDURE
Install or remove a component from the server in the following procedure.
Hard Disk Drive
The server can contain up to three hard disk drives.
IMPORTANT:
„
Please turn off computer and unplug its power cord before removing
or installing hard disk drives.
„
Do not use any hard disk drives that are not authorized by NEC.
Installing a third-party hard disk drive may cause a failure of the
server as well as the hard disk drive.
„
All hard disk drives must accept the same interface.
„
Jumper switch setting on backplane board may need to be changed
depending on hard disk drive type. Set the switch appropriately
according to the figure below.
For N8103-116/117/118 board, you need not to change jumper
setting. (Use setting for SATA HDD LED.)
Disk bay 2
For second hard disk drive Disk bay 1
For first hard disk drive Disk bay 3
For third hard disk drive
Mother board Backplane board
SATA hard disk drive
SAS hard disk drive
Strapped
Strapped