NEC N8100-14522F, Руководство пользователя

Страница: 120 / 320

4-52 Configuring Your Server
The following describe the clearing procedure.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-11 for details.
„
Do not disassemble, repair, or alter the server.
„
Do not remove the lithium battery.
„
Do not connect the ground line to a gas pipe.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-11 for details.
„
Never attempt to lift the server only by yourself.
„
Make sure to complete board installation.
„
Do not install the server on a rack with leaving covers removed.
„
Do not pinch your finger with mechanical components.
„
Note high temperature.
„
Do not pull out a device from the rack if the rack is unstable.
„
Do not leave more than one device being pulled out from the rack.
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare.
2.
Pull the server out from the rack (see Chapter 9).
3.
Remove the top cover (see Chapter 9).
4.
Verify the location of CMOS clear jumper switch.
5.
Change jumper switch setting from "Protect" to "Clear".
6.
After five seconds later, reinstall the jumper.
7.
Reassemble the server and then press the POWER switch to turn on the server.
8.
Press
F2
during POST to run the BIOS Setup utility, and configure the mother board
again.