Installing Server
3-5
●
Checking the place to install
Decide the place (height) to install.
To keep balance, install it as low as you can
on the rack.
To install the rack, the height for 4U is
required.
IMPORTANT:
To install this device to the rack, the space for 1U is required for installing the
USB-compatible floppy disk drive, in addition to the space for 4U.
Next to the square hole of the rack, an imprinted mark is placed for 1U (This is the unit to show the
height of the rack). This device is as high as 4U (about 176 mm), so install it between the imprinted
marks that indicate the height of 4U.
●
Installing this device
Follow the steps below to set the 4U chassis to the rack.
IMPORTANT:
■
4U chassis weighs about 10 Kg. To mount, remove or replace it, be sure to hold it with
two or more people.
■
The following are the required accessories. Check if you have them all.
- Tool Name
Qty
- Bracket
2
- Washer for panhead screw
4
- Plate screw
8
- Panhead screw
8
TIPS:
Core nuts (4 pieces) are not included. Use the core nuts that are attached to the rack.
Imprinted mark
Places to install
core nuts
Imprinted mark
(2 imprinted
marks for 5Us)
4U
(the height
for installing
this device)
