natus OLYMPIC SMART SCALE 50, Инструкция по эксплуатации

Страница: 39 / 64

OLYMPIC SMART SCALE Model 50/51 Instruction Manual 6-7
Repair Procedures
Replacing the Battery Pack
If the battery pack no longer holds its charge, replace it.
Required parts:
„
Battery pack (part no. 401391)
„
Screwdriver
To replace the battery pack:
1
If the scale is on, press
ON/OFF
to turn off the scale, then unplug the
power cord.
2
Loosen the two screws that secure the battery compartment cover to the back of
the scale, disconnect the battery connection, then remove the battery pack (see
Figure 6.5).
Figure 6.5 Replacing the battery pack
3
Place the new battery in the compartment, then connect battery connector.
4
Place the battery compartment cover into position, then gently tighten
its screws.
5
Connect the power cord to an electrical outlet. The CHARGING light will
illuminate.
6
Properly dispose of the nickel-cadmium (Ni-Cad) battery. The internal battery
pack can be recycled by contacting the Rechargeable Battery Recycling
Corporation (RBRC) at 1-800-822-8837 or www.rbrc.org. If the battery pack is
not recycled, it must be disposed of as Hazardous Waste.
NOTE
#
Partially discharging and recharging the rechargeable batteries repeatedly over time
will lead to premature battery failure. To prolong battery health, occasionally run the scale
on battery power alone until the cells are fully discharged, then fully recharge the battery
for 2.5 hours.
WARNING
Only use the replacement Olympic Battery Pack (part no. 401391)
.
Use of an incorrect
battery pack may cause equipment damage, explosion, or fire.
Battery compartment cover
NOTE
#
Charge new batteries for approximately 2.5 hours to reach full charge before operating
the Smart Scale on battery power.