natus OLYMPIC SMART SCALE 50, Инструкция по эксплуатации

Страница: 26 / 64

4-2 OLYMPIC SMART SCALE Model 50/51 Instruction Manual
Charging the Battery
Charging the Battery
The Smart Scale has internal rechargeable batteries that automatically charge
( CHARGING signal illuminates) whenever the scale is connected to a functioning
electrical outlet.
To recharge the battery:
„
Plug the power cord into a hospital-grade electrical outlet. Allow the battery to
recharge for at least 2.5 hours.
Battery Charge Life
When fully charged, the scale will operate for approximately three hours of
continuous use — enough battery power for about 100 weighings.
Low Battery (LO BAT)
The LO BAT signal indicates how much battery life remains:
„
If slowly blinking, the battery is getting low.
„
If lit and steady, approximately 30 minutes of continuous battery-powered
operation time remains.
„
If rapidly blinking, the battery charge has been depleted and the scale will
automatically turn off. Connect the scale to a functioning electrical wall outlet
for recharging.
When LO BAT appears, connect the scale to an electrical outlet to recharge
the battery.
CAUTION
Connect this device directly to a properly grounded hospital-grade outlet.
NOTE
#
„
Partially discharging and recharging the rechargeable batteries repeatedly over time
will lead to premature battery failure. To prolong battery health, occasionally run the
scale on battery power alone until the cells are fully discharged, then fully recharge the
battery for 2.5 hours.
„
Charge new batteries for approximately 2.5 hours to reach full charge before operating
the Smart Scale on battery power.
„
Batteries can be continuously charged without damage.
„
The scale can be used while the batteries are charging.