Muratec F-360, Руководство по полевой инженерии

Страница: 176 / 290

4-20
4.14 Service Call Error
When certain machine problems occur these message will appear in the LCD.
4.14.1 Call For Service
Symptom: “Call For Service” is in the LCD.
Suggested corrective action:
1. Check the following connection:
•
Lamp assembly to the Inverter PCB (CN2)
•
Inverter PCB (CN1) to the Harness to the Main control PCB (P208)
2. Replace the lamp and/or the Inverter PCB.
4.14.2 Please Call Service
When certain machine problems occur a “Please Call Service” message will appear in the LCD. When
this message appears, access the printer maintenance mode / Service call function to determine the
cause of the “Please Call Service” error message.
To access the printer maintenance modes:
<For F-360>
1. Press MENU , * , 0 , 6
.
The mode are contained within two main menu level.
2. Use the cursor key to select “Service Call” mode and then press ENTER .
3. The error message will be displayed.
For example, when “Heater error” and “Drum Fuse Error” has occurred, the LCD will show:
Use cursor key to show the other printer error message if more printer errors have been occurred.
<For F-320>
1. Press MENU , * , 0 , 6
.
The modes are contained within two main menu level.
Set Replace Counter
/ /Enter
Service Call
/ /Enter
2. Using the cursor key to select “Service Call” and then press ENTER .
3. The error message will be displayed.
For example, when “Heater error” and “Drum Fuse Error” has occurred, the LCD will show:
Service Call : 2
Heater Error
Use cursor key to show the other printer error message if more printer errors have occurred.
Number of errors
Number of errors