3-103
3.8 Printer maintenance mode
In case of the following, use this mode.
•
When you have replaced the Fuser unit and/or Transfer roller.
•
When “Please Call Service” message appears in the LCD, access this mode to determine the cause of the
“Please Call Service” error message.
When you replace the Fuser unit or Transfer roller, you must set the count of replacement
manually
To access the printer maintenance modes:
Note:
Do not set these counters if you did not replace the Fuser unit or Transfer roller.
1. Press
MENU, *, 0, 6
.
The mode is contained within two main menu levels.
2. Press or to select
“Set Replace Counter”
on the LCD and then press
ENTER
.
3. The LCD shows:
4. If you have replaced the Fuser unit, select
“Replace Fuser”
, then press
ENTER.
Otherwise, skip to step 6.
5. Press
[Enter]
to reset the fuser replacement counter.
After resetting the Fuser unit replacement counter, the machine will return to the standby mode.
6. If you replaced the transfer roller, select
“Replace Transfer”
, then press
ENTER.
The LCD shows:
7. Press
[Enter]
to reset the Transfer roller replacement counter.
After resetting the Fuser unit replacement counter, the machine will return to the standby mode.
Содержание F-360
Страница 12: ...2 1 Section2 Machine Composition 2 1 F 360 Interconnect Block Diagram...
Страница 13: ...2 2...
Страница 14: ...2 3 F 320 Interconnect Block Diagram...
Страница 254: ...6 29 13 Attach the paper tray of the 2 Bin unit...
