DIS185SSI4F AIR COMPRESSOR • OPERATION MANUAL — REV. #0 (12/19/16) — PAGE 29
OPERATION
AIR HOSE CONNECTION
1. Connect the load air hose to the air outlet valves as
shown in Figure 20.
2. Make sure that both air outlet valve handles are placed
in the
CLOSED
position.
Figure 20. Connecting Air Hose
START-UP
1. Turn the main switch (ignition switch) key to the
ON
position (Figure 21).
Figure 21. Main Switch (ON Position)
2. Next, press the
RUN
button (Figure 22) on the control
panel for at least 2 seconds to start the preheat cycle.
Figure 22. Run Button (Starting)
OPE
N
CLOSED
AIR
HOSE
AIR
OUTLET
VALVE
CLOSED
MAIN SWITCH
OFF
ON
OFF
OFF
OFF
RUN
RUN
3. Verify that the
preheat
LED on the control panel is lit
(
YELLOW
).
4. The engine will start automatically after the preheat
cycle has been completed.
5. Once the engine has started and has reached normal
operating speed, the
RUN
LED (Figure 22) will turn on
and the unit will enter warm-up mode.
6. When the warm -up time is set to
AUTO
mode (default),
the engine fluid will be checked automatically. The
warm-up cycle will continue until the engine fluid
temperature has reached 86 °F (30 °C).
7. During warm-up (Figure 23) the compressor air
pressure will be displayed on the 7-segment display
and the display LED will be lit (
GREEN
).
Figure 23. Warm-up Mode
8. Once the engine temperature has reached 86 °F (30 °C),
the warm-up cycle will end and the unit will switch to
the no load mode.
9. Verify that the compressor air pressure has increased
(Figure 24) by reading the value on the 7-segment
display
Figure 24. No Load Mode
NOTICE
Units are shipped from the factory in
AUTO
mode.
When in
AUTO
mode, the warm-up time is set to a
minimum of 5 seconds. To change the warm-up cycle
time, please reference "
WARM-UP ADJUSTMENT
" in
the operation section of this manual.
PSI AIR PRESSURE
rpm ENGINE SPEED
°F AIR TEMPERATURE
°F WATER TEMPERATURE
DISPLAY
DISPLAY
PSI AIR PRESSURE
rpm ENGINE SPEED
°F AIR TEMPERATURE
°F WATER TEMPERATURE
