drIvInG & safety — 2
2 0 0 8 K n I G h t
Indicator Lights and Sound Patterns:
ON
or normal condition is indicated by
green
. The CO detector has power and is
sensing air for the presence of CO Gas.
The alarm will not sound.
Flashing
red
indicates low CO alarm
condition along with
four
beeps then
OFF
for five seconds. The alarm will
sound and can be reset by the
TEST/
RESET
button. The CO detector has
detected the presence of 60 ppm.
Steady
red
indicates a
CO ALARM
condition. The detector has sensed the
presence of levels over 100 ppm of
Carbon monoxide. The alarm horn will
sound continuously until the
RESET
switch is reset.
Alternating
red
and
green
indicates a
malfunctioning alarm.
Alarm
When the alarm sounds have the detector and
the motorhome checked by an authorized service
technician as soon as possible. Never disconnect
a CO detector to silence an annoying alarm.
Evacuate the motorhome immediately when the
red light is lit and the alarm sounds. Do a head
count to check that all persons are accounted for.
Call the nearest fire department and ask them to
determine the source of the Carbon Monoxide.
DO NOT
re-enter the motorhome until it has
been aired out and the problem corrected.
Potential Sources of CO when operating
the motorhome:
Engine Exhaust
Portable Grills
Portable Space Heaters
Camp Fires
Gas Stoves and Ovens
Generator Exhaust
Portable Generators
Nearby Motorhomes
Defective Engine Exhaust System
Testing
Test Procedures:
Test the Carbon Monoxide detector operation
after the motorhome has been in storage, before
each trip and at least once a week during use.
Test the alarm by holding the
TEST/RESET
button in until the alarm sounds. The alarm will
sound four beeps and the indicator lamp goes
steady
red
. Six seconds later the alarm will
again beep four times and the indicator light
goes steady
green
.
Peak Level Memory:
The CO detector has the capability to
remember the level of Carbon Monoxide that
activated the alarm. Press the
TEST/RESET
button for less than one second and observe the
visual and audible signals.
One beep
and
one
green
flash indicate
memory is clear.
Two beeps
and
two red
flashes indicate
less than 100 ppm.
Three beeps
and
three
red
flashes
indicate less than 200 ppm.
Four beeps
and
four red
flashes indicate
greater than 200 ppm.
NOTE
Memory is erased when power is
disconnected for 15 seconds.
Cleaning & Maintenance
Use a vacuum cleaner to remove dust or any
other buildup on the detector.
DO NOT
wash.
Wipe the detector with a damp cloth and dry
with a towel.
DO NOT
open the detector for
cleaning.
DO NOT
paint the detector. It is
recommend that the Carbon Monoxide detector
be replaced every 5 years. The CO detector has
no user service parts. If there is a problem with
the detector refer to an authorized service center.
DO NOT REMOVE POWER
.
INSPECT
Check the CO detector weekly and at
the beginning and end of each trip.
fIre extIngUISHer
The fire extinguisher in the motorhome is
located near the main entrance door. Please read
the operating instructions that are printed on the
fire extinguisher. If there is any doubt on how to
operate the fire extinguisher practice using it.
020150b
Содержание 2008 Knight
