131
2 0 0 8 K n I G h t
water systems —
4. Open the solid waste drain (black)
valve. Allow the black tank to drain.
5. Connect one end of the pressure
regulator to the water source and
the end to a non-potable water hose.
Connect the non-potable hose to the
tank flush fitting.
6. Turn on the water source and allow
water to rinse the black tank at least
three minutes. Never operate the
system unattended. Ensure the water
flows freely though the drain hose.
7. When completed, turn off the water
source and close the black water valve.
8. Open the grey water valve. The water
in the grey tank will flush remaining
solids from the hose. With the grey
water valve open, run two gallons of
water down any drain to flush grey
tank. The grey valve remains open
until the next drain cycle, or time of
departure.
WARNING
Operating the flush system unattended
can risk flooding. Use the tank flush
system each time the holding tanks are
cycled. Failure to routinely use the flush
system will result in a clogged spray
nozzle. Turn off the water supply when
finished flushing the tank.
9. When preparing for travel, close both
dump valves. Undo restraining devices
from the hose. Disconnect the hose
from the termination outlet by rotating
the fitting counterclockwise 90º.
10. Raise the hose and drain using hand
over hand method working the hose
towards shore fitting. Rinse the hose
with outside facility and repeat the
hose drain process.
11. Remove the hose from shore fitting.
Install hose in carrier and lock door.
Secure the termination cap (required by
law in some states).
12. If desired, add chemicals to the tanks
to control odor. Follow the directions
given by the manufacturer of the
chemical.
NOTE
Dump the black tank before driving.
WaSte pUmp (optIonal)
The waste pump (Sani-Con system) is a self-
priming impeller pump designed to minimize
clogging when draining the tanks. The system
comes with a 1½” outlet hose with sewer pipe
adapter and a 13 gallon per minute macerator
pump.
When operating Sani-Con it is recommended
to wear disposable gloves, safety glasses
and protective clothing. The house battery
disconnect switch, located in curbside battery
compartment, must be on for the Sani-Con
system to operate. The waste pump operates on
12 Volts from the house battery.
INFORMATION
For additional information consult RV
Sani-Con literature or website:
www.emptythetanks.com
WARNING
NEVER place in
the toilet personal
hygiene products,
cigarette butts,
paper towels, table
scraps, grease, any
tissue that remains
in one piece, any object that can be
considered foreign. These objects will
damage the Sani-Con system and void
manufacturer’s warranty.
WARNING
Never leave the Sani-Con pump
unattended while in use. DO NOT allow
the pump to run dry for any period of
time. Damage to the pump impeller and
Sani-Con system will result and void
manufacturer’s warranty.
040460w
100220
100220b
Содержание 2008 Knight
