water systems —
12
2 0 0 8 K n I G h t
5. Turn on the water at the source.
6. The water pump can either be OFF or
ON. It will not affect the water pump
to leave it on.
7. Open each faucet, one at a time, to rid
any trapped air inside the pipes.
CAUTION
Some water sources develop high water
pressure, particularly in mountainous
regions. High water pressure is anything
over 55 psi (pounds per square inch).
Excessive water pressure may cause
leaks in water lines and/or damage the
water heater.
Power Water Hose Reel (Optional)
To extend, manually spool the hose to
water source for connection. Hose retrieval is
accomplished by pushing the water hose reel
switch that powers the 12 VDC motor. The
rocker type switch prohibits the reel from being
inadvertently left on.
Water pUmp
The water pump
pressurizes the fresh water
system when not connected
to city water. The water
pump is self-priming,
operating on demand as
water is used. The water
pump is located in the water
service center.
Operation Requirements:
House battery disconnect
switch must be on.
Turn on battery cut-out switch.
WARNING
Before leaving the motorhome for
extended periods of time (i.e. overnight
or longer) be sure that the city water
supply and water pump have been
turned off. Damage from neglect will be
the responsibility of the owner, not the
manufacturer.
The water pump can be operated from
these following locations:
Hallway Systems Control Panel
Water Service Center
Kitchen
To turn the water pump ON or
OFF:
Momentarily press the water
pump switch. The indicator
lamp illuminates when the
water pump is turned on.
CAUTION
DO NOT continue water pump
operation if the fresh water holding tank
is empty. Damage to the water pump
or electrical supply system
may result.
To operate the water pump after unhooking
from a city water supply or after storage:
Close all drain valves and low point
drains.
Fill the fresh water tank.
Open the hot and cold water valves of
each faucet.
Turn the water pump
ON
. Wait for the
water lines and the hot water tank to fill.
Close each faucet when it delivers a
steady stream of water (cold water
faucets first).
Water Pump Troubleshooting
Vibration induced by road conditions can
cause the plumbing or pump hardware to loosen.
Check the water pump system for components
that are loose. Many symptoms can be resolved
by tightening the hardware. Check the following
items:
Water pump will not start or blows the fuse:
Check the electrical connections, fuse
or breaker, main switch and ground
connection.
Is voltage present at the pressure switch
on the pump? If voltage is present, the
pressure switch may be faulty. As a test,
temporarily bypass the pressure switch.
Check the charging system for correct
voltage and good ground.
Water pump inlet
screen: Located on
water pump in water
service center. Clean
every two months.
040586
040537c
Service Center
Water Pump
Switch
040624
Содержание 2008 Knight
