19
2 0 0 8 K n I G h t
electrIcal systems - chassIs — 9
13. ALT FAIL:
Failure within the
alternator charging system.
14. SEAT BELT WARNING:
A warning
light that indicates seat belts are not
fastened.
15. ATC (Automatic Traction Control):
The ATC indicator light will illuminate
steady when the ignition key is turned
ON. The light remains illuminated
until the first brake application. The
indicator illuminates when the ATC
switch is pressed. See Section 10 for
more information.
16. LOW WASH:
Windshield washer
fluid is becoming low.
17. LOW AIR:
Air tank pressures are out
of range. Check air pressure.
18. DPF:
The DPF (Diesel Particulate Filter)
light turns on when an active regeneration
cycle is necessary and has not been
able to initiate. See Section 10 for more
information.
19. HEST:
The HEST (High Exhaust System
Temperature) light turns on when exhaust
temperatures reach 1450º F. This indicates
that an active regeneration cycle is
underway. No fault exists as long as there
are no other active warning lights. See
Section 10 for more information.
Switches
Dash switches come either
with or without a bar light.
The bar light indicates the
item/function is active. Icon
lighting for both switch
types illuminate with panel
lamps. Dash switches can be
illuminated and dimmed if desired, by turning
the headlight switch counterclockwise. Rotating
clockwise dims and turns off the switch light.
Driver’s Console & Dash
DRIVER SHADE:
Operates the power sun
visor located on driver’s side.
PASS SHADE:
Operates the power sun visor
located on the passenger side.
PEDAL IN/OUT:
PEDAL IN/OUT: Use the
Pedal In/Out switch to adjust the brake and
throttle pedals. The switch moves the pedals
inward or outward. When the pedals reach
the end of their traveling distance the motor
will stop. Release the switch. Do not continue
moving the pedals. Damage to the motor and/
or fuse may result if operation of the switch
continues after reaching the fullest extend or
retract position.
ATC:
The ATC system improves traction on
slippery or unstable surfaces by preventing
excessive wheel slip (See Section 10 for
detailed information). An indicator light on the
dash turns on with switch.
CRUISE ON/OFF:
Turns cruise
ON
or
OFF
.
CRUISE CANCEL:
Signals the cruise system
to disengage without losing the current speed
memory.
CRUISE SET/RES:
Cruise SET -
Actuates the Cruise Set
function of the engine controller.
Cruise RES -
Actuates the Cruise
Resume function of the engine controller.
NOTE
The cruise control system will not
operate with the exhaust brake engaged.
WARNING
To take control of the motorhome do
not use cruise control in heavy traffic or
on roads that are winding, slippery or
unpaved. Do not shift the transmission
into “N” (Neutral) with the cruise
control on as high engine RPM run up
occurs until the cruise control is turned
off.
ICC:
Flashes all exterior lights at once.
EXH BRAKE:
The exhaust brake is an
auxiliary braking device for slowing down the
motorhome. The exhaust brake is an effective
device for speed control in town and on local
routes. The exhaust brake is not a substitute for
service brakes. Do not neglect service brake
maintenance.
060066n
Содержание 2008 Knight
