drIvInG & safety — 2
22
2 0 0 8 K n I G h t
Taillight Configuration:
Taillights come in different configurations
referred to as a 2-wire or 3-wire configuration.
A 2-wire configuration has all red lens. A 3-
wire configuration usually has red and amber
lens. Amber is used for turn signals only and
red for taillight and brake light. These systems
are electrically different. Whenever hooking
a 2-wire system to a 3-wire system, or vice
versa, a converter box must be installed for
correct taillight function. A taillight converter
is available from auto and RV supply stores.
DO NOT
attempt to wire a tow plug connector
if unfamiliar with these systems. A trained
technician will install the proper converter so the
taillights and turn signals work correctly on the
motorhome and towed vehicle or trailer when
the tow plug connection is made.
Tow Plug Connection
The motorhome is pre-wired from the factory
with an electrical connection for towing. The
connection is located on the rear cap, near
the hitch receiver. Convoluted tubing protects
the tow harness wires. Current draw should
not exceed ten amps for each designated light
circuit. Within the electrical connection is a
positive terminal for use when towing a trailer
equipped with a battery. The positive terminal
maintains the charge of the trailer battery.
When preparing a tow plug connection, strip
the wires 3/8". Twist the wire strands and place
under the clip and secure the screw. Make sure
there are no loose strands of wire that could
short against the case or other terminals.
DO
NOT
accidentally mirror image the trailer
connection.
CAUTION
Positive terminal connection of the tow
plug remains live at all times. When
towing a trailer equipped with a battery,
unplug the electrical tow connection
when parked. Failure to unplug the tow
connection may result in discharged
chassis batteries.
rear vISIon SyStem
The motorhome can be equipped with either a
rear camera, or an optional three camera vision
system. The rear vision system consists of a
camera with a microphone both located at the
rear of the motorhome. The microphone aids in
communication while the camera is designed
to provide the driver with a rear view when
backing up. The rear camera is adjustable up and
down and is controlled by the driver.
On the optional three camera system,
side cameras are located at the front of the
motorhome directly above the front wheels
and are not adjustable. This system provides
the driver with a rear view as well as roadside
and curbside views of the motorhome and a
microphone for audio communication.
Turning the main power switch to ON will
allow continuous operation of the rear vision
system when the ignition key is turned on.
Features:
POWER BUTTON -
Press this button
to turn the unit
ON
or
OFF
. Turning the
unit
ON
will allow continuous operation
of the rear vision system when ignition
key is on.
080462f
031204c
Содержание 2008 Knight
