chassIs InformatIon — 10
208
2 0 0 8 K n I G h t
Extend the jack position according to the
indicator lamp. Example: If the indicator
lamp is lit under Jack Extend Switch
- Rear, the rear of the motorhome is low.
Press and hold the Rear button. Both rear
jacks will extend. Once level, the system
will automatically stop. The Power Gear
Level Light will illuminate. Release the
switch. Pressing Right or Left will extend
a single rear jack accordingly.
Turn off the remote panel.
Turn off the Ignition switch.
Automatic Leveling
The automatic function of the leveling system
should only engage when the site is relatively
level and solid to prevent excessive twist/stress
to the frame. It is essential that there is no
movement in the motorhome prior to and during
the automatic leveling process.
Automatic Leveling Operation:
Follow the instructions in
Prior to
Leveling
.
Turn the ignition switch to the On
position.
Press the
ON
/
OFF
button to turn the
system on.
Press the Auto switch. The pump motor
activates and the appropriate jacks
automatically extend and level the
motorhome.
NOTE
A Jacks Down warning light will
illuminate when the jacks are extended.
The alarm will sound if the jacks are
down and the park brake is released or
transmission placed in gear.
The motorhome is level when the LED’s
next to Jack Extend switches are off
and the green Power Gear Level light is
illuminated.
Turn off the remote panel.
Turn off the ignition switch.
NOTE
If additional height
or surface support is
needed, construct a
1' x 1' wooden block
made from two pieces
of ¾" plywood for a
total thickness of 1½".
Drill a hole in one corner
and use the awning wand to slide the
wooden block under the jack pad.
Retracting Leveling Jacks
Turn the ignition switch to the On
position.
Apply the parking brake.
Turn On the remote panel.
Momentarily press the All Jacks Retract
button. If retracting in manual mode, the
All Jacks button must be held until the
Jacks Down LED goes out.
Once the Jacks Down LED goes out, the
jacks should be fully retracted. Make a
visual inspection to ensure that all jacks
have fully retracted before moving the
motorhome.
INSPECTION
Before moving the motorhome always
perform a visual inspection to be sure
that all jacks have fully retracted.
Remove any debris that may be on the
jack pad.
If the jacks fail to extend or retract:
Apply the park brake, turn the ignition
to the On position and place the
transmission in Park.
If jacks still do not operate, check
the leveling system fuse in the front
distribution box.
NOTE
The
hydraulic
pump is
equipped
with an
internal
thermal
breaker for
protection
against
overheating.
If the pump
is used repeatedly in a short period
of time the breaker will trip. It resets
automatically in 5 to 30 minutes.
020185b
Wood Support
Block
Содержание 2008 Knight
