Mitsubishi Electric Q66DA-G, Руководство пользователя

Страница: 168 / 190

8
- 2 8.1 Error Code List
8
TROUBLESHOOTING
(1) When two or more errors occur, the latest error code is stored.
(2) If Error code marked with *1 occurs, D/A conversions for all the channels
stop. Therefore, after correcting the offset/gain setting, make the initial setting
again.
(3) Error code 161 marked with *2 is not stored in the Error code (Un\G19).
It is written to the Completion status area, (S) + 1, of the G(P).OGSTOR
instruction.
(4) Error code marked with *3 can be cleared by turning on Error clear request
(YF).
(5) If an error marked with *4 occurs continuously, it is added to the error history
of GX Developer for every conversion cycle.
Table8.1 Error code list (2/2)
Error code
(decimal)
Error description Processing
40 *
3
The offset value is equal to or larger than the gain value.
indicates the channel number causing the error.
Reset so that the offset value is smaller than the gain
value.
500*
3
More than one channel was set at the same time during
offset/gain settings. Set the correct value in Offset/ gain setting mode offset/
gain specification (Un\G22, Un\G23).
60 *
3
*
4
The specified digital value is outside the range.
indicates the channel number where the error occurred.
Set a value that is within the range.
61 *
3
The warning output upper/lower limit value setting is out-
side the range -32000 to 32000.
indicates the channel number incorrectly set.
Correct the contents of CH Warning output upper/lower
limit value (Un\G86 to Un\G97) to within the range -32000
to 32000.
62 *
3
The warning output lower limit value is equal to or greater
than the warning output upper limit value.
indicates the channel number incorrectly set.
Make setting so that the warning output upper limit value is
greater than the warning output lower limit value.
700*
3
The analog adjustment output in the offset/gain setting
mode is outside the specified value range.
Change the contents of Offset/gain adjustment value spec-
ification (Un\G24) so that it is within the range from –3000
to 3000.
710*
3
The value set for Offset/gain range setting is other than
D
H
, E
H
, or F
H
.
Set either D
H
, E
H
, or F
H
for offset/gain range setting
(Un\G25).
80 *
3
The increase/decrease digital limit value setting is outside
the range 0 to 64000.
indicates the channel number incorrectly set.
Correct the contents of CH Increase/decrease digital
limit value (Un\G70 to Un\G81) to within the range 0 to
64000.
90 *
3
The scaling upper/lower limit value is set outside the range
of –32000 to 32000.
indicates the channel number set incorrectly.
Correct Scaling upper/lower limit value (Un\G54 to
Un\G65) within the range of –32000 to 32000.
91 *
3
The scaling lower limit value is equal to or greater than the
scaling upper limit value.
indicates the channel number set incorrectly.
Set CH Scaling upper/lower limit value (Un\G54 to
Un\G65) so that the scaling upper limit value is greater
than the scaling lower limit value.