Mitsubishi Electric MR-J3-B, Инструкция по эксплуатации

Страница: 60 / 225

3 - 19
3. SIGNALS AND WIRING
(C) Output signals
Signal name Symbol
Connector Pin
No.
Function/Application
Encoder A-phase
pulse
(Differential line
driver)
LA
LAR
CN3-6
CN3-16
Encoder B-phase
pulse
(Differential line
driver)
LB
LBR
CN3-7
CN3-17
Outputs pulses per servo motor revolution set in parameter No. PA15 in the
differential line driver system. In CCW rotation of the servo motor, the encoder
B-phase pulse lags the encoder A-phase pulse by a phase angle of /2.
The relationships between rotation direction and phase difference of the A- and
B-phase pulses can be changed using parameter No. PC03.
Output pulse specification and dividing ratio setting can be set. (Refer to
Section 5.1.9.)
Encoder Z-phase
pulse
(Differential line
driver)
LZ
LZR
CN3-8
CN3-18
Outputs the zero-point signal in the differential line driver system of the
encoder. One pulse is output per servo motor revolution. turns on when the
zero-point position is reached.
The minimum pulse width is about 400 s. For home position return using this
pulse, set the creep speed to 100r/min. or less.
Analog monitor 1 MO1 CN3-4
Used to output the data set in parameter No. PC09 to across MO1-LG in terms
of voltage. Resolution 10 bits
Analog monitor 2 MO2 CN3-14
Used to output the data set in parameter No. PC10 to across MO2-LG in terms
of voltage. Resolution 10 bits
(d) Power supply
Signal name Symbol
Connector Pin
No.
Function/Application
Digital I/F power
supply input
DICOM CN3-5
CN3-10
Used to input 24VDC (150mA) for input interface. The power supply capacity
changes depending on the number of I/O interface points to be used.
Connect the positive terminal of the 24VDC external power supply.
24VDC 10%
Pins are connected internally.
Digital I/F common
DOCOM CN1-46
CN1-47 Connect of DC24V external power supply.
Common terminal for input signals such as EM1. Pins are connected internally.
Separated from LG.
Monitor common
LG CN3-1
CN3-11
Common terminal of M01 M02
Pins are connected internally.
Shield SD Plate
Connect the external conductor of the shield cable.