Mitsubishi Electric MR-J3-B, Инструкция по эксплуатации

Страница: 26 / 225

1 - 9
1. FUNCTIONS AND CONFIGURATION
(2) MR-J3-200B MR-J3-350B
Test operation select switch (SW2-1)
Used to perform the test operation
mode by using MR Configurator (Setup
software).
Spare (Be sure to set to the "Down"
position).
7
9
6
8
5
4
3
2 1
0
F
E
D
C
B
A
1 2
ON 4E
SW1
SW2
TES
Cooling fan
SW1
SW2
8
7
6
5
4
3
2
1
0
F
E
D
C
B
A
9
1
2
Section 3.13
Display
The 3-digit, seven-segment LED shows the servo
status and alarm number.
Chapter 4
Rotary axis setting switch (SW1)
Used to set the axis No. of servo amplifier.
Section 3.13
Main circuit power supply connector (CNP1)
Connect the input power supply.
USB communication connector (CN5)
Connect with the personal computer.
Section 3.1
Section 3.3
Section 11.5
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output
Section 3.2
Section 3.4
Name/Application
Detailed
Explanation
Used to connect the servo system controller or the front
axis servo amplifier.
Section 3.2
Section 3.4
Section 3.2
Section 3.4
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
SSCNET cable connector (CN1B)
Section 3.1
Section 3.3
Motor power supply connector (CNP3)
Connect the servo motor.
Encoder connector (CN2)
Connector for connection of the servo motor encoder. Section 3.4
Section 11.1
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Section 11.6
Chapter 12
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Section 11.6
Chapter 12
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Name plate
Section 1.5
Section 3.1
Section 3.3 Protective earth (PE) terminal ( )
Ground terminal.
SSCNET cable connector (CN1A)
Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative
brake option.
Section 3.1
Section 3.3
Mounting hole
(4 places)