Mitsubishi Electric MR-J3-B, Инструкция по эксплуатации

Страница: 53 / 225

3 - 12
3. SIGNALS AND WIRING
(b) Termination of the cables
1) CNP1 CNP3
Solid wire: After the sheath has been stripped, the cable can be used as it is.
7mm
(0.276in)
Sheath
Core
Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to avoid
a short caused by the loose wires of the core and the adjacent pole. Do not solder the core as
it may cause a contact fault. Alternatively, a bar terminal may be used to put the wires
together.
Cable size Bar terminal type
[mm
2
] AWG For 1 cable For 2 cables
Crimping tool Maker
0.34 22 AI0.34-8TQ
0.5 20 AI0.5-8WH AI-TWIN2 0.5-8WH
0.75 18 AI0.75-8GY AI-TWIN2 0.75-8GY
1 18 AI1-8RD AI-TWIN2 1-8RD
1.5 16 AI1.5-8BK AI-TWIN2 1.5-8BK
2.5 14 AI2.5-8BU AI-TWIN2 2.5-8BU
CRIMPFOX-ZA3 Phoenix Contact
2) CNP2
CNP2 is the same as MR-J3-100B or smaller capacities. Refer to (1) (b) in this section.
(c) As twin type connector for CNP2 (L
11
, L
21
) is the same as MR-J3-100B or smaller.
Refer to (1) (C) in this section.