Mitel MiVoice Office 400, Системное руководство

Страница: 43 / 257

System Overview
43
Mitel SMB Controller
syd-0657/2.0 – R6.0 – 09.2018
– Upload the Licence file in the WebAdmin Setup wizard .
Your communication system is now registered and activated.
The new licences are enabled. You can see them on the licence overview page.
Note
If you do not activate the communication server, it will switch to a restricted operating mode
after four hours.
2. Click Apply and Next .
The second page, Setting up the IP addressing , opens.
Set the Gateway address and a Primary DNS server .
Note
If you do not set these parameters, you cannot load audio guides or update Mitel SIP phone
strings from the Mitel download server.
3. Click Apply and Next .
The third page, Configuring media resources , opens.
On this page, the system proposes to configure the DSP resources automatically.
You can use this configuration to begin with. You can always change the DSP set-
tings under
Configuration - System - Media resources ( =ym ). Check the options
for FoIP and DECT resources, if applicable.
4. Click Apply and Next .
The fourth page, Setting up the numbering plan , opens.
This page displays the predefined call numbers of the internal numbering plan. You
can edit or delete these numbers.
5. Click Apply and Next .
The fifth page, Setting up SIP providers , opens.
This page allows you to set up a SIP provider profile or import a predefined SIP pro-
vider profile from an XML file. If your communication system will not be connected to
the public network through a SIP provider, skip this step.
6. Click Apply and Next .
The sixth page, Setting up users, terminals and DDIs(DIDs) , opens.
On this page, you set up users, terminals and DDIs(DIDs).
7. Click Apply and Next .
The seventh page, Setting up the auto attendant , opens.
This page allows you to set up an auto attendant, if needed. The auto attendant en-
ables you to specify, what options are offered to a caller while greeting the caller.
The caller can select any of the options by dialing a single digit.
8. Click Apply and Next .
This completes the setup. Click Restart for the configurations to take effect.